Input
54
Protect sealing parameters
This function can be used to protect the sealing parameters and settings against unintention-
al changes by the operator. The function is activated or deactivated with a secret pin (person-
al identiļ¬cation number).
Enter the four-digit PIN to activate and deactivate the function. **** is displayed instead of
the entered numbers. The protection function is switched over after entering the correct PIN.
The PIN is 0000 when delivered from the factory.
The following functions are blocked for the user in protected mode:
All sealing parameters Scroll key operating modes
Settings menu
The following are permitted:
Selection of parameters P1..P6..P50 and all other operating functions
Basting process can be activated but the basting parameters are not accessible
The PIN can be changed with this function
Enter current PIN Enter new PIN Repeat new PIN
If the PIN is forgotten, it can be reset to the value 0000 with the RESET TO FACTORY
SETTING function (see chapter 13.12: Resetting to factory setting).
To Next Page
Loading...