7 - 6
Controls
7.08.02 Operational mode keys
There are two different modes of operation. The selected mode is shown by the diode of
the respective key.
- Operational mode SEWING has been selected
- Operational mode ENTER
has been selected
- If the operational mode ENTER
has already been selected, the standard condition is
selected.
7.08.03 Function keys
Arrow keys
(right/left)
- Positioning of cursor if several values are entered in one line
- Turning over menu pages
- Changing zones during programming and seam interruption
Plus/Minus keys
- Increasing or reducing input values
- Selection of sign for sign-dependent inputs
- Selection of program number
Esc-key
- Interruption of functions without taking over the input value
- Return to superior menu functions
Clear key
- Setting input values at 0
Enter key
- Confirmation of an input value / finishing an input
- Switching to another zone when programming or interrupting a seam
- Confirmation of error correction after error alarm
7.08.04 Number keys
Beneath the display there is a strip with number keys.
Depending on the operating condition, the keys have the following functions:
- Executing a function illustrated by the symbol of the corresponding key
- Input of a numerical value (if no symbol is entered with a number key)
- Selection of functions or of the next menu level
Esc
Clear
To Next Page
Loading...
Need help?
General
