13 - 11
Adjustment
1
4
13.05.09 Clearance between presser foot and needle plate
Requirement
When hand lever 1 is raised there should be a clearance of 5 mm between the presser
foot and the needle plate.
2
6
7
● With the hand lever lower the presser foot onto the needle plate.
● Loosen the adjustment screw for the presser foot presser (reduce pressure)
● Push out bolt 1 (screw 2) and remove connection element 3 from the yoke of lever 4.
● By turning the balance wheel bring lever 5 to its furthest point of reversal.
● Place feed dog adjustment gauge under the presser foot with the recess facing down.
● Loosen screw 6 and push out bolt 7.
● Adjust presser foot (screw 8) at the side so that the edge of the presser foot is parallel to
the bottom feed dog.
● Lower lifting piece 9 as far as possible and tighten screw 8.
Screws 2 and 6 remain loosened for further adjustments.
3
5
8
9
Fig. 13 - 10
To Next Page
Loading...
