Sewing
10 - 1
10 Sewing
Following steps must be carried out before work begins, irrespective of how the machine
is equipped.
● Check the oil level of the machine, see Chapter 12.02 Oil level of the machine.
● Check the air pressure, see Chapter 12.04 Checking/adjusting the air pressure
● Switching on the machine, see Chapter 7.01 On/off switch.
10.01 Machines without graphics control panel (Manual Sewing)
On machines without a graphics control panel 2 values are set for the fullness.
After the machine has been switched on, following functions are available:
● By operating the knee switch it is possible to change from one amount of fullness to
the other, see Chapter 7.04 Right knee switch.
● Using the keyboard, the value for the selected fullness can be changed in part steps,
see Chapter 7.07 Keyboard.
10.02 Machines with graphics control panel
10.02.01 Manual sewing with one amount of fullness (program number 0)
● Select SEWING mode.
● Select program selection
function
(number key 1).
● Enter program number 0.
● Confirm input with Enter.
0
● Using the keyboard, the value for the fullness can be changed in part steps, see
Chapter 7.07 Keyboard.
Displays in the status bar:
Program number
The number of the selected seam program appears next to this symbol.
”Manual sewing with one amount of fullness” is selected with program number 0.
1 2
3
4 5 6 7 9 0
Enter
8
Esc
Clear
bdf
00