Sewing
10 - 5
Functions in the pictogram bar:
Program selection
This function opens a direct menu for selecting the desired seam program.
Program interruption
This function interrupts the seam program cycle (see Chapter 10.02.04 Program
interruption).
Stitch counter on/off
With this function the stitch counter can be switched on or off.
Alternate sewing
When this function is activated, the left and right parts are processed alternately. The
function is activated, when the symbol is displayed on a dark background. If only one part
is programmed, this symbol is not displayed.
Left part/right part
The symbol illustrated on a dark background shows which part is being worked on
currently. By selecting the corresponding function, it is possible to switch over to the
desired part. The symbols are only displayed, if both parts are programmed.
Type of material
To achieve the same results (amounts of fullness) when working with different types of
materials, with these functions 3 types of material can be selected directly, see
Explanations in Chapter 10.02.01 Manual sewing with one amount of fullness.
10.02.04 Program interruption
If the cycle of a seam program is interrupted (e.g. due to thread breakage), the Program
interruption
function must be selected.
● Switch over to manual SEWING
after the key is pressed the first time.
● It is possible to continue sewing manually.
● Using the arrow keys it is possible to select the seam area, in which the seam pro-
gram should be continued.
● After pressing the key the second time, the selected seam area is entered,
programmed SEWING is continued.
In the last seam area, after the thread has been cut using the pedal (pedal
position 4 in Chapter 7.02 Pedal) the interrupted seam program is started
from the beginning.
To Next Page
Loading...
Need help?
General
