Phoenix LT4 - Page 56

Phoenix LT4 Lane Machine Operation, Maintenance, and Parts Manual
4-2 Rev. Date: 01/22 61-900040-000
Perform the following tasks with the machine in the operating position:
Oiling Area
 Check the oil level and add oil if needed.
 Ensure the cap is in place and securely tightened.
 Check the wicking foams for nicks, tears, and missing pieces along the edge.
 Unlatch the tank oil spring and tilt the tank rearward. With a clean cloth, gently
wipe the wicking foams and the front of the oil tank. Reinstall the tank oil spring.
Cleaning Area
 Check the amount of cleaning solution in the cleaner tank and add cleaning
solution if needed. Do NOT refill the cleaner tank prior to storing the machine or
cleaner could leak out of the vent hole in the cap.
 Ensure the cap is in place and securely tightened.
 Check the foam pads below the spray heads. Rinse and squeeze out excess
moisture. Replace the pads as needed.
Waste
 Remove and empty the waste tank. Do NOT dump recovery tank in a septic tank
or sanitary sewer system. Follow your local environmental regulations for the
best method of disposal. Rinse the waste tank under running water.
 Add 1-2 ounces of defoamer into the tank. Cover the vacuum hose port and swish
the defoamer around to coat the inside of the tank. Defoamer will need to be
added to the waste tank daily when new, but as the tank becomes "seasoned" it
may only need to be added on a weekly basis.
 Check the vacuum seal on the side of the vacuum motor. Replace if it is wrinkled,
buckled, or torn.
 Replace the waste tank being careful not to bend or abrade the vacuum pump to
waste tank seal.
Power Cord
 Unplug the power cord from the power inlet on the control panel.
 Unplug the power cord from the outlet.
 Coil the power cord around the base of the handle. Coiling in long loops will help
keep the cord from twisting.
Frame and Exterior Components
 Wipe the optical sensor lens with a dry, clean, and soft cloth. Do not use any type
cleaner on the sensor.
 Wipe the nozzles.
 Wipe the frame.
 Wipe the touch screen with a clean cloth.