MAC address: The MAC address of the interface (this can be
cannot be changed).
DHCP mode: - The device is over the set
Address available.
Client The device obtains an IP address
from a DHCP server.
server The device is over the set
Address available and provides others
IP addresses available to devices.
IP address: The IP address of the device.
Subnet mask: The subnet mask of the device.
Gateway: The IP address of the gateway (optional).
DNS server: The IP address of the DNS server (optional).
A notice:
This group is only displayed if an “Ethernet over USB” adapter is
connected to the device. The adapter is available separately and can
only be used with the standard version devices and the CONNECT-II-
LTE device.
If the web interface should not be accessible via the USB LAN interface,
simply deactivate the DHCP mode and leave the IP address and subnet
mask fields empty.
Important:
If you use the interface as part of the bridge interface or the connection
type CONNECT is set in your device and the interface is used as a router
interface, these settings are not available.
Important:
Changing some settings may require you to disconnect an existing
connection to a partner device and re-establish network connections.
Only make changes to the configuration if it does not disrupt operation
and then check the status of the device. When using the CONNECT
Page 67 Handbook CONNECT / CONNECT-II / CONNECT-CONTROL V1.13
To Next Page
Loading...
Need help?
General