Important:
By triggering factory settings, all settings you have made on the device
will be lost. Before you can use the device again, you must commission it
again.
4.3.5.4 Device
The “Device” group contains some general settings for networking the
device in the CONNECT cloud:
Surname: The name of the device. This only serves to
easier identification.
Number: The unique number of the device.
Password: The password of the device used to set up a
Connection to this device is required.
In the sub-block “Partner device” you can set the automatic connection to
another device from your CONNECT cloud:
Connection: Indicates whether the device connects automatically
a device from your CONNECT cloud.
Number: The number of the device to which a connection is
being made should be built.
Password: The password of the device to which you are
connecting should be built.
Page 53 Handbook CONNECT / CONNECT-II / CONNECT-CONTROL V1.13
To Next Page
Loading...
Need help?
General