3 Installation
Before you can start using your CONNECT device, you need to access
the device's web interface and set some basic settings.
Please ensure that all conditions stated in the previous “System
Requirements” chapter are met. You can then start accessing the device.
3.1 Access to the device
Before you can configure the device according to your needs and finally
use it, you must first connect to the device. Depending on the device
type, there are different options available to you, which are listed in more
detail on the next pages.
Important:
This chapter describes the delivery status of the device. You can use the
web interface to configure the device's interfaces as desired, so that
access to the device via another interface is also possible.
Once your device is in a configured state, you also have the option to
access your device's website using the keyword "connect" on the PC and
peripheral interface (if used).
To do this, simply enter the keyword “connect” in the address bar of your
web browser instead of the IP address. This access also works if the
computer you want to use to access the device is in a different subnet
than the CONNECT or the interface of the CONNECT device does not
yet have an IP address.
3.1.1 CONNECT / CONNECT-II device
Access to the CONNECT / CONNECT-II devices is usually via the WLAN
interface.
First make sure that the WLAN interface of your laptop or tablet is
activated and display the networks that are within range. In the list of
WLAN networks you should now find a network with the SSID
Handbook CONNECT / CONNECT-II / CONNECT-CONTROL V1.13 Page 8
To Next Page
Loading...
Need help?
General