Sleep Tab
92
Remote TTL Flash Sleep Mode
Normally your ControlTL transmitter tells all remote TTL flashes to sleep when the camera sleeps. This saves
batteries in the remote flash but could cause the flash to take a moment to be ready before the next trigger. Enable
this control to have your ControlTL transmitter wait to tell all remote E-TTL II flashes to sleep until a time after the
camera sleeps. This control can be independently over-ridden by a remote flash using Local Flash Sleep Mode.
Remote TTL Flash Sleep Delay
Sets the number of seconds after the camera sleeps (meters go inactive) when remote TTL flashes will go to sleep.
Local Flash Sleep Mode
(FlexTT5 Only)
If you are using a standard transmitter like a Plus or MultiMAX, the sleep command is never sent over the air, and
the remote flash mounted on the FlexTT5 would always remain powered on. Enabling this control causes the
FlexTT5 connected flash to remain awake for a set period after any radio activity, then enter its sleep mode for
power saving. This control overrides Remote TTL Flash Sleep Mode.
To Next Page
Loading...
