Sleep Tab
93
Modeling Light Sleep Mode
(PowerST4 / PowerMC2 Only)
If you are using a standard transmitter like a Plus or MultiMAX, a sleep command is never sent over the air, and the
remote flash mounted on the radio would always remain powered on. Enabling this control causes the connected
flash to remain awake for a set period after any radio activity, then enter its sleep mode for power saving.
The Modeling Light Sleep Delay setting sets when a locally connected flash will go to sleep after the last incoming
radio trigger.
Hibernate Mode
(PowerMC2 Only)
The Paul C. Buff Einstein E640 is always drawing power when connected to a power source, even when asleep or
"Hibernating" - you'll notice the PowerMC2 is operating and blinking even when the Einstein is "Off". The
PowerMC2 can Hibernate the Einstein E640 flash after a certain period of inactivity, controlled by the Hibernate
Delay setting. This sets the period of time after an incoming trigger that the Einstein will Hibernate.
Misc Tab
Utility Tab Quick Links
Update
Channel
Flash
HyperSync/HSS
PowerTracking
Modeling
Sleep
Misc
Exposure
To Next Page
Loading...
