27
7. Aim the camera at an object exactly four feet (1.2 meters) away and press the
S1/S10 button down half way. The following should happen:
• A green circle within a green square will be visible in the viewfinder.
• A red figure “4” will be visible in the viewfinder (USA cameras) -OR-
a red figure “1.2” will be visible in the viewfinder (non-USA cameras).
• The LCD panel will display “4.0 FT” (USA cameras) -OR- the LCD panel will
display “1.2M” (non USA cameras).
8. Cover the transducer using the fingers or palm of your left hand (Figure 3-4) or you
can cover the transducer with photographic tape. Use care to prevent covering the
photocell. Press the S1/S1 button half way down. (This simulates an infinity
exposure.) The following should happen:
• No red figure should be visible in the viewfinder.
• The LCD panel will display “0 0 FT” (USA cameras) - OR- the LCD panel will
display ”0 0 M” (non USA cameras).
• Depending on the ambient light available, a flashing yellow triangle within a yellow
square (with warning beeps) or a green circle within a green square will be visible
in the viewfinder. The warning yellow triangle will appear in low light level
situations, while the green circle will appear if there is adequate light for a good
exposure.
To Next Page
Loading...
Need help?
General
