46
• To turn exposure adjustment OFF: Press the MODE button until the symbol for
the Exposure Adjustment function is displayed. Then press the up or down arrow
button to remove the bar from beneath the symbol. Press the MODE button once
to return to a full display.
4. Cover the Photocell.
5. Set the Test Selector Switch to 7000 ZLS.
Test Procedure
1. Press the Shutter Button fully and note the reading on the ZLS Meter. Compare the
reading to the Specification.
2. If the ZLS Test reading is out of Specification, replace either the Flashtube Assembly
or the Strobe Board and retest.
3. If the ZLS Test reading is within specification but the Strobe Exposure (Graywall)
reading is still out of spec, perform the hybrid Test below.
To Next Page
Loading...
