48
Test Procedure
1. Press the Shutter Button fully and note the reading on the ZLS Meter.
2. Repeat the procedure two more times, noting each Meter reading. Compare the
readings to the Specification.
3. If the test readings are not within Spec, perform the Hybrid Adjustment procedure
and retest.
4. If this adjustment does not bring the Hybrid Test reading within specification, proceed
to the Blade Speed Test below.
5. If the Hybrid Test reading is within spec but the Strobe Exposure Test reading is still
out of spec, replace the Exposure Flex and retest.
To Next Page
Loading...
