Poly G200 User Manual

Setting Description
IPv6 Enables or disables IPv6:
• Manual: Manually configure the additional settings in the following
rows
• Automatic: The system automatically configures addresses for
the IPv6 settings
• Disable: Disable IPv6
Link Local Displays the IPv6 address used for local communication within a
subnet.
This setting is only configurable when Manual is selected.
Site Local Displays the IPv6 address used for communication within the site or
organization.
This setting is only configurable when Manual is selected.
Global Address Displays the IPv6 internet address.
This setting is only configurable when Manual is selected.
Default Gateway Displays the default gateway assigned to the system.
This setting is only configurable when Manual is selected.
Configure SVC Call Settings
If you use SVC mode, use the Poly RealPresence Clariti Ensemble server as the call server.
Make sure to enable SVC deployment mode.
Procedure
1. In the system web interface, go to Server Settings > Call Server.
2. Configure the following settings and select Submit.
Setting Description
Device Name Specifies the name of your G200 system registered to the RealPresence Clariti
Ensemble server.
Note: To avoid duplicate device names, you must change the default device
name.
Server Address Specifies the RealPresence Clariti Ensemble server you want to use.
Note: If the RealPresence Clariti Ensemble server doesn’t use the default
FQDN/IP port 443, you must specify the port in the server address as
<ip>:<port>. For example: 10.11.12.13:446.
Configuring Network Settings
24

Poly G200 Specifications

General

Brand	Poly
Model	G200
Category	Conference System
Language	English