Powering On and Off
The Poly G200 doesn’t have a power button. When you plug in the power cord, the device turns on.
Navigating the System
You can use the system web interface to complete the setup process and manage your G200 system.
The local interface has a subset of the administration settings that are available in the system web
interface.
Note: If you enable a provisioning service, any settings provisioned in the system might display as read-
only settings in the system web interface.
Related Links
Provisioning the System on page 17
Access the System Web Interface
You can perform most of the calling and configuration tasks on the G200 system web interface that you
perform on the system’s local interface.
The initial setup process requires you to set a password to enter the system web interface.
Procedure
1. Open a web browser and enter the system IP address.
2. Enter the Username (default is admin), the Password, and select Log In.
Change the Password
You can change the G200 system admin password from the system web interface.
Poly recommends that only administrators access the Poly G200 system configuration. Therefore, Poly
provides only one credential for the system web interface.
Procedure
1. Go to Admin Settings > Password.
2. Configure the following settings and select Submit.
Setting Description
Old Password Specifies the existing password for the administrator account used when
logging in through the system web interface. When creating a password for the
first time, leave this setting blank.
New Password Specifies a new password.
The password is case sensitive and must be less than 40 characters without
spaces.
Getting Started with Poly G200
6
To Next Page
Loading...
Need help?
General
