Basic Poly Studio LED Indicators
The Poly Studio device provides an LED bar above the camera to help you understand its behaviors.
Basic Poly Studio LED Indicators and Status
Indicator Position Status
Chasing white All while alternating Boot initialization in progress
Blinking blue Two in the middle Bluetooth in discovery
Solid blue for three seconds Two in the middle Bluetooth paired
Solid amber Two in the middle Standing by
The privacy cover is open, and the
camera is in sleep mode with no
active video output
Blinking green or white All Incoming call
Solid green or amber Two in the middle Outgoing call
Solid green or white One or two (when in the middle),
indicating the tracked speaker or
the direction of the camera
Working
The lights are green with supported
applications in the following cases:
• Tracking people in group
framing and speaker tracking
mode
• Indicating the direction of the
camera that you customize in
pan-tilt-zoom (PTZ) mode
Solid white for three seconds Two in the middle Saving a preset
Solid red All Muted microphone
Blinking red Two in the middle On hold
Run the Setup Wizard
When you power on your G200 system for the first time or reset it, the setup wizard starts and leads you
through the minimum configuration steps.
The setup wizard is also known as the out-of-box (OOB) wizard. It's available during the initial setup, after
the system reset with system settings deleted, or after a factory restore.
Procedure
1. Power on the G200 system by plugging in the power cable.
Setting Up the System
11
To Next Page
Loading...
Need help?
General
