Do you have a question about the Polycom KIRK 6000 and is the answer not in the manual?
Power Supply | 100-240 VAC, 50-60 Hz |
---|---|
DECT standard | DECT |
Voice Codec | G.711, G.729 |
Protocols | SIP, H.323 |
Connectivity | Ethernet |
Operating Temperature | 0°C to 40°C |
Storage Temperature | -20°C to 60°C |
Dimensions (W x D x H) | 44 mm |
Compatibility | KIRK Wireless Handsets |
Introduction, overview of manual content, and important pre-installation information.
Overview of the KWS6000 solution, its components, and system requirements.
Guidelines for planning and deploying the KWS6000, including placement and synchronization.
Step-by-step instructions for installing the KWS6000 server and optional media resource hardware.
Procedure for installing the Codec Module into a KIRK Media Resource for enhanced codec support.
Detailed guide for installing the KIRK Base Station, including placement and connection.
Instructions for installing the KIRK Repeater to extend wireless coverage.
Guide on handset setup, battery installation, charging, and serial number retrieval.
Information on network setup, including DHCP and static IP address configuration.
Steps for powering up, connecting, and configuring the KWS6000 via web interface.
Instructions for powering up and configuring KIRK Media Resources via web interface.
Guide for powering up and configuring KIRK Base Stations via web interface.
Process for registering and subscribing handsets to the KWS6000 system.
Procedures for managing handsets: viewing, unsubscribing, exporting/importing data, and adjusting.
System-wide management tasks for KWS6000, Media Resources, and Base Stations.
Information on sending and describing MSF (Message Service Function) messages.
Information on product compliance, safety warnings, and RF exposure.
General safety instructions and warnings for installing and using the equipment.
Details of the product's limited warranty terms and conditions.
Information regarding the open-source software included with the product.