Polycom KIRK Wireless Server 8000 User Manual

Polycom KIRK Wireless Server 8000 & KIRK Wireless Server 2500 Configuration Guide
117 Polycom, Inc.
Figure A HyperTerminal Window
4 Hold down the Shift key and then press the Z key. A command prompt is
displayed.
In the prompt type loadb and then press Enter. The following text is
displayed in the command prompt.
## Ready for binary (kermit) download to 0x00010000 at 115200 bps...
5 From the Transfer menu, select Send File.
6 Select the uimage file you want to download, in the protocol item select
Kermit, and then click the Send button.The following text is displayed on
completion. Note that
## Total Size = 0x00231708 = 2299656 Bytes
## Start Addr = 0x00010000
Note the Total Size may vary from uimage to uimage.
Note The Total Size may vary from uimage to uimage. 0x00231708 is an
example. You must always use the correct image size.
7 Type protect off 1:1-63 and then press Enter. The following text is
displayed on completion.
Un-Protect Flash Sectors 1-63 in Bank # 1
8 Type erase 1:1-63, and then press enter. The following text is displayed
completion.
Erase Flash Sectors 1-63 in Bank # 1
.............................................................. done
9 Type cp.b 0x10000 (Start Addr) 0x50020000 <Total Size> where the last
number must be the TotalSize of the uimage (in this example 0x231708) .
All numbers are in hexadecimal.
10 Press Enter. The following text is displayed on completion.
Copy to Flash... done
11 Type boot and then press Enter. The system restarts.

Polycom KIRK Wireless Server 8000 Specifications

General

Brand	Polycom
Model	KIRK Wireless Server 8000
Category	Server
Language	English