Polycom KIRK Wireless Server 8000 - Page 66

Polycom KIRK Wireless Server 8000 & KIRK Wireless Server 2500 Configuration Guide SIP Configuration
61 Polycom, Inc.
DTMF
Signalling
Send as RTP
Enable the check box (Real-Time
Transport Protocol), if you want
the keypad signalling sent as RTP
packets with DTMF code.
Note. Some SIP servers
understand both methods, so if
you enable both methods for
sending DTMF, then ciphers will
be sent twice.
Offered rfc2833
payload type
Payload type for rfc2833 in SDP
offers. The default value is 96.
Send as SIP
Info
Enable the check box, if you want
the keypad signalling sent as SIP
INFO.
Tone Duration
(msec)
Enter the time length of the tone in
milliseconds. The default value is
270.
Message
waiting
indication
Enable
Indication
Enable the check box, if you want
to display MWI in the handset..
Enable
Subscription **
Enable the check box, if you want
to subscribe to MWI indications
from the SIP proxy.
Subscription
Expire (sec) *
Enter the number of seconds
before MWI subscription will be
renewed. The default value is
3600.
Media
Packet Duration
(msec) *
It defines the duration of the RTP
media stream packets. Select
between 10, 20 and 40 msec.
Media Type of
Service * **
IP type of service for voice. The
default setting is 184.
Port Range Start
* **
Port range start used for RTP. The
default value is 58000.
Parameter Details Description