Appendix F - Secure Communication Mode
Polycom®, Inc. 972
3 Click the Security tab.
The Management Security Properties dialog box is displayed.
4 Select the Secured Communication check box.
This box is checked by default when the MCU is in Ultra
Secure Mode.
5 Select the Certificate Validation mode by checking or clearing the Skip certificate validation for
user logging session field as set out in the following table:
Management Network Properties - Certificate Validation Mode
Field: Skip certificate validation for user logging session
Status RMX and Client Certificate Requirements
Un-checked
(Restricted Mode)
• The RMX must install a personal certificate issued by a CA.
• The Client must install a personal certificate issued by a CA.
• The public key of the CA must be installed in the RMX.
Note: When the RMX Manager is the Client, all Personal Certificates
in the workstation's Certification Repository are sent to the RMX.
When using the RMX Web Client, Internet Explorer gives the user the
option to select the Personal Certificate to be used from the
workstation's Certification Repository.
Checked
(Un-restricted Mode)
• The RMX must install a personal certificate issued by a CA.
• No additional configuration is required for the Client.
To Next Page
Loading...
