Using Conference Profiles
Polycom®, Inc. 25
Default Profile Settings in CP Conferencing Mode
The Collaboration Server is shipped with a default Conference Profile for CP conferences which allows
users to immediately start standard ongoing CP conferences. These are also the default settings when
creating a new Profile. The default settings are as follows:
Recording
AVC recording only
Site Names
AVC endpoints only
Managed by the
endpoint (not via
MCU)
Message Overlay
AVC endpoints only
* Entry Queue & Destination Conference must have the same profile (i.e. SVC only to SVC only, Mixed CP and SVC
to Mixed CP and SVC)
*** For AVC, the LPR error resiliency is used, however for SVC endpoints, new error resiliency methods are used
.
‡ Cascading is not supported on Collaboration Server (RMX) 1800 with no DSP cards.
Default CP Only Conference Profile Settings
Setting Value
Profile Name Factory_Video_Profile
Line Rate 384Kbps
Video Switching Disabled
Operator Conference Disabled
Encryption Disabled
Packet Loss Compensation (LPR
and DBA)
Enabled for CP Conferences
Auto Terminate • After last participant quits - Enabled
• When last participant remains - Disabled
Auto Redialing Disabled
Exclusive Content Mode Disabled
TIP Compatibility Disabled
Enable FECC Enabled
Enabled Gathering Phase Enabled
Conferencing Capabilities in the Different Conferencing Modes
Feature CP Only Mixed CP & SVC SVC Only VSW
To Next Page
Loading...
