Appendix I - Polycom Open Collaboration Network (POCN)
Polycom®, Inc. 1038
For more information see Modifying System Flags.
Procedure 2: Configuring Collaboration Server to statically route outbound SIP
calls to DMA or CUCM
1 In the IP Network Services Properties dialog box, click the SIP Servers tab.
2 In the SIP Server field, select Specify.
3 In the SIP Server Type field, select Generic.
4 Set Refresh Registration to every 3600 seconds.
5 If not selected by default, change the Transport Type to TCP.
6 In the SIP Servers table:
a Enter the IP address of the DMA or CUCM in both the Server IP Address or Name and Server
Domain Name fields.
b The Port field must be set to it’s default value: 5060. DMA and CUCM use this port number by
default.
7 In the Outbound Proxy Servers table:
a Enter the IP address in the Server IP Address or Name field. (The same value as entered in Step
6a.)
b The Port field must be set to it’s default value: 5060.
(By default, the Outbound Proxy Server is the same as the SIP Server.)
TIP HD Video Resolution by Line Rate
Line Rate Video Resolution
Line Rate >=3Mbps HD1080p30
3Mbps > Line Rate >= 936kbps HD720p30
Line Rate < 936kbps Call is dropped.
To Next Page
Loading...
