Polycom realpresence 1800 - Cisco Equipment

Appendix I - Polycom Open Collaboration Network (POCN)
Polycom®, Inc. 1034
Cisco Equipment
To configure the various Cisco entities the following procedures are required.
CUCM
» Configure the CUCM to send and receive calls from the H.323 network.
a With Neighbored IOS and DMA Gatekeepers
b With IOS Gatekeeper
For more information see the Polycom Unified Communications Deployment Guide for Cisco
Environments.
IOS Gatekeeper
● Set up zones and gateway type prefixes to enable dialing to DMA and Collaboration Server systems.
IOS and DMA Gatekeepers (Neighbored)
● Configure the Cisco IOS Gatekeeper for two separate zones.
Polycom Equipment
The following table lists the Polycom products supported within the various Deployment Architecture.
Only Collaboration Server configurations are described in detail in this document.
Configuration procedures for all other solution components are described in the Polycom Unified
Communications Deployment Guide for Cisco Environments.
Supported Polycom products
Polycom TIP and SIP Version(s)
Polycom DMA 7000 system V4.0
Polycom RealPresence Collaboration Server (RMX) 2000/4000
systems
V7.6 and higher
Immersive Telepresence Systems:
• RPX 200 and 400 systems
• OTX 300 system
• TPX HD 306 system
• ATX HD 300 system
V3.0.3
Requires TIP option key.
Requires Polycom Touch Control.
HDX Systems:
• 7000 HD Rev C
• 8000 HD Rev B
• 9006
• 4500
V3.0.3
Requires TIP option key.
Peripheral Polycom Touch Control 1.3.0
SIP ONLY (no TIP support) Version(s)