Additional Conferencing Information
Polycom®, Inc. 206
To select the lecturer and enable the Lecture Mode while starting the conference:
» In the Conference Properties - Participant dialog box, enable the Lecture Mode using one of the
following methods:
To automatically select a defined participant:
1 Add participants to the conference either from the Address book or by defining new participants.
2 In the Lecturer field, select the lecturer from the list of the defined participants.
To automatically select the lecturer:
» In the Lecturer field, select [Auto].
In this mode, the conference speaker becomes the lecturer.
To select the lecturer and enable the Lecture Mode during the ongoing conference:
1 Make sure that the participant you want to designate as the lecturer has connected to the
conference.
To Next Page
Loading...
