System Configuration Flags
Polycom®, Inc. 798
SIP_ENABLE_FECC By default, FECC support for SIP endpoints is enabled at the MCU
level. You can disable it by manually adding this flag and setting it
to NO.
SIP_FAST_UPDATE_INTERVAL_E
NV
Default setting is 0 to prevent the Collaboration Server from
automatically sending an Intra request to all SIP endpoints.
Enter n (where n is any number of seconds other than 0) to let the
Collaboration Server automatically send an Intra request to all SIP
endpoints every n seconds.
It is recommended to set the flag to 0 and modify the frequency in
which the request is sent at the endpoint level (as defined in the
next flag).
SIP_FAST_UPDATE_INTERVAL_E
P
Default setting is 6 to let the Collaboration Server automatically
send an Intra request to Microsoft OC endpoints only, every 6
seconds.
Enter any other number of seconds to change the frequency in
which the Collaboration Server send the Intra request to Microsoft
OC endpoints only.
Enter 0 to disable this behavior at the endpoint level (not
recommended).
SIP_FIPS_MODE Controls availability of PFX/PEM Certificate Method.
Range:
• YES - PFX/PEM is not available for selection in the user
interface.
• NO - PFX/PEM is available for selection in the user interface.
Default:
• Standard Security Mode - NO
• Ultra Secure Mode - YES
SIP_FORMAT_GW_HEADERS_FO
R_REDCOM
Controls whether the RMX adds special gateway prefix and postfix
characters to the user portion of the SIP URI expressed in the
From and Contact headers of SIP messages sent during calls
involving Gateway Services. The addition of these characters can
result in call failures with some SIP call servers. It is recommended
to set this flag to YES whenever the RMX is deployed such that it
registers its conferences to a SIP call server.
Range: YES, NO
Default: NO
The MCMS System Flags
Flag Description Add?
To Next Page
Loading...
