Appendix B - Active Alarms
Polycom®, Inc. 912
Hot backup: Network issue
Hot Backup: Paired MCU is
unreachable.
Initialization of ice stack failed
Insufficient resources The number of resources in the license is higher than the actual system
resources.
Check the media cards or insert a media card.
Insufficient UDP Ports When defining fixed port, the number of defined UDP ports is lower than
the required ports.
Configure additional ports.
Internal System configuration during
startup
System configuration during startup.
Wait until Collaboration Server startup is completed.
Invalid System Configuration
IP addresses of Signaling Host and
Control Unit are the same
IP addresses of Signaling Host and Control Unit are identical.
Assign different IP addresses to the Signaling Host and Control Unit.
IP Network Service added
IP Network Service configuration
modified
IP Network Service was modified. Reset the MCU.
IP Network Service deleted IP Network Service was deleted. Reset the MCU.
IP Network Service not found IP Service not found in the Network Services list.
Configure the IP Network Service.
IPMC software upgrade in component
IPS 140 test result not received
ISDN/PSTN Network Services
configuration changed
New ISDN/PSTN configuration. Reset the MCU for the change to take
effect.
LDAP TLS: Failed to connect to OSCP
responder
Management Network not configured Configure the Management Network.
Missing Central Signaling configuration Configure the central signaling.
Missing Central Signaling IP
configuration
MPL startup failure. Authentication not
received.
Authentication was not received from Switch. Check the switch card.
MPL startup failure. Management
Network configuration not received.
Management Network message was not received. Check the Switch
card.
Active Alarms
Alarm Text Alarm Description
To Next Page
Loading...
