111
Polyend Play Manual Rev 1
NOTES
Sequencing Patterns
6
5. Select ‘Chords’ Fill algorithm. Ensure the upper ll parameter is set to
‘Chords’. Press the left side [Screen] button to ensure the algorithm
type is in focus. Turn (Screen) when the upper parameter is highlighted
to select the algorithm, in this example select ‘Chords’.
6. Set the ‘Chord’ Fill genre. Press the left side [Screen] button to ensure
the algorithm genre is in focus. Turn (Screen) when the lower parameter
is highlighted to select the genre preset. This is a pre-programmed
chord pattern from a factory selection of 48 patterns.
7. Press [Fill] button again. The selected steps will be populated with the
pattern based on genre preset and samples from the sample pool.
8. The programmed note samples can be changed individually to another
sample by manually selecting it.
Chord and Bass lls use note values dened in the selected genre
template. For Beat lls this note can be changed to a xed note value from
within the Settings > Fill Cong options. This is accessed by pressing
(Screen) button.
These settings also allow MIDI output channel assignment per instrument.
Kick Channel Jack Channel 1
Snare Channel Jack Channel 1
HiHat Channel Jack Channel 1
Kick Note From Template
Snare Note From Template
HiHat Note From Template
Synth Channel Jack Channel 1
Settings
Back Play Perform
Fill
Delete
MIDI Channel Output for
Synth Fill tracks
Defaults are ‘From Template’ for beat ll notes and ‘Jack Channel 1’ for MIDI Out.
Beat Fill Note. Use
template or a dened note.
To Next Page
Loading...
