Printronix LP654C - Page 119

- 120 -
Item
Factory
default
settings
Description
DHCPv6
Disable
Set to obtain the IPv6 address
automatically. Set to Disable when you do
not use the IPv6 address.
Automatic
setup (WPS)
WPS-PBC
Executed when setting is done by pressing
the WPS button of the wireless LAN access
point.
WPS-PIN
Executed when the PIN code displayed on
this machine is registered with the wireless
LAN access point.
Wireless
Network
Selection
xxxxxx
......
Displays a list of wireless LAN access point
names found by the search.
Manual
Setup
SSID
Input the SSID.
Security
Disable
Sets the security of the wireless LAN
function.
WEP Key
Input the WEP key.
WPA
Encryption
Type
Displays the WPA-PSK encryption type. The
setting is carried out automatically according
to the security settings. (Impossible to
switch in this menu)
WPA Pre-
shared Key
Input the pre-shared key. Displayed when
[Security] is set to any other value than
[Disable] or [WEP].
Execute
Executes the changes to security settings.
Wireless Reconnection
Reconnects to the wireless LAN
(infrastructure).
*1 Factory default setting values are different according to the country or region.
*2 The values are displayed with the unit set in [Admin Setup] - [Tray Setup] - [Unit of Measurement].
Admin Setup
Item
Factory
default
settings
Description
Enter Password
**********
Input the password required to enter the
Admin Setup menu.
Network
Setup
General
Setup
Extended Network
Disable
Selected when you want to enable any other
network than the standard wired LAN.
Enabling Default Gateway
Wired(LAN1)
Specify the network connection method for
segment-based communication.
TCP/IP
Enable
Enables/Disables the wired LAN.
NetBIOS over TCP
Enable
Enables/Disables the NetBIOS over TCP
protocol.
Web
Enable
Enables the access from the web browser.
Displayed when the TCP/IP protocol is
enabled.
Telnet
Disable
Enables the access using Telnet.
Displayed when the TCP/IP protocol is
enabled.
FTP
Disable
Enables the access via FTP.
Displayed when the TCP/IP protocol is
enabled.