Printronix LP654C - Page 120

- 121 -
Item
Factory
default
settings
Description
IPSec
Disable
Displayed only when IPSec is enabled. It
can be changed to Disable only.
Displayed when the TCP/IP protocol is
enabled.
SNMP
Enable
Enables the access from SNMP.
Displayed when the TCP/IP protocol is
enabled.
Network Scale
Small
Normally, [Small] is selected.
Network Factory Defaults
Execute
Restores network menu settings to factory
default settings.
Wired(LAN1)
Setup
Wired(LAN1)
Enable
Enables/Disables the wired LAN1.
IP Address Set
Auto
Set to obtain the IPv4 address automatically
or input it manually.
IPv4 Address
xxx.xxx.xxx.x
xx
Input the IPv4 address manually. Displayed
when [IP Address Set] is set to [Manual].
Subnet Mask
xxx.xxx.xxx.x
xx
Input the subnet mask. Displayed when [IP
Address Set] is set to [Manual].
Gateway Address
xxx.xxx.xxx.x
xx
Input the gateway address. Displayed when
[IP Address Set] is set to [Manual].
DHCPv6
Disable
Set to obtain the IPv6 address
automatically. Set to [Disable] when you do
not use the IPv6 address.
HUB Link Setting
Auto
Negotiate
Sets the connection method to the hub.
USB Setup
USB
Enable
Enables/Disables the USB interface.
Speed
480 Mbps
Sets the maximum baud rate using a USB
interface.
Soft Reset
Disable
Enables/Disables the soft reset command.
Serial Number
Enable
Enables/Disables the USB serial number.
The USB serial number is used to identify
the USB device connected to the PC.
Offline Receive
Disable
When [Enable] is selected, data can be
received even if the printer is offline.
USB Memory Interface
Enable
Enables/Disables the USB memory
interface.
Connected Host
Normal
Set to [Specific] in case of timeout when
printing is done on this machine which is in
the sleep mode.
Power consumption in the sleep mode is
higher than the state where it is set to
[Normal].
Print Setup
Personality
Auto
Selects the operating language of the
printer.
Copies
1
Sets the number of copies.
The value set in the printer driver takes
priority.
Duplex
On or Off
*1
Sets whether or not to implement duplex
printing.
The value set in the printer driver takes
priority.
Binding
Long Edge
Specifies the binding method for duplex
printing.