The value set in the printer driver takes
priority.
Sets whether to check the mismatch
between the paper size of the print data and
that of the tray.
Sets the functions of auto switching the
printing paper from A4 to Letter when A4
paper runs out and Letter paper is loaded,
or from Letter to A4 when Letter paper runs
out.
Sets the resolution.
The value set in the printer driver takes
priority.
Sets the toner save level.
Specifies whether to apply toner save to
100% black.
Sets the print mode of mono pages.
[Auto] controls the print mode with a good
balance.
[Color Mode] is suitable for printing a large
amount of color pages.
[Normal Mode] is suitable for printing a large
amount of mono pages.
Sets whether or not to prepare for the next
color printing after the printing has
completed.
Specifies the print orientation. For
PostScript, this setting is disabled.
Sets the size of the drawing area when the
size is not specified by the paper size edit
command from a PC.
Set when white streaks appear between
adjacent colors.
Sets the default value of paper width for
custom paper sizes.
Sets the default value of paper length for
custom paper sizes.
Sets the tray selection number of PostScript
level-1 operator commands.
Specifies the PS communication protocol for
network connection.
Specifies the PS communication protocol for
USB connection.
Specifies the paper size for direct printing of
PDF files.
Set the reduction ratio when [Scaling Size]
is selected in [PDF Paper Size].
Sets whether to prioritize print quality or
print speed when a PDF is printed.
Selects the location of the font to be used.
Selects the number of the font to be used.
To Next Page
Loading...
