If enabled, printing is performed after
verifying that the print data has not been
changed. The integrity of print data is
guaranteed, but the time to start printing will
be longer.
Sets the method for erasing the print data.
Specifies that the data cannot be
overwritten after it has been erased and
cannot be restored.
If you overwrite, it will take longer to erase.
Value range: No overwrite/Zero out once
Sets the retention period of the print data.
After the print data is saved, if the print data
is not printed after the set period, the print
data is automatically deleted.
Value range: 15 min/30 min/1 hour/2
hours/4 hours/8 hours/12 hours/1 day/2
days/3 days/4 days/5 days/6 days/7 days
Sets whether to save restricted print data.
When [Private Print only] is selected, print
data other than private print will not be
accepted.
Selects whether to verify the job password
when the access control is enabled.
Selects whether to perform job search at the
same time as unlocking the panel when the
access control is enabled.
The printer comes with a built-in process
simulation tool that simulates standard
printing colors on the printer.
Adjusts the degree of under color removal.
Selects whether to use halftone for C, M, Y
100% output.
Selects whether to perform CMYK
conversion in the simple (high speed) mode.
Sets whether to display a message when
the supplies or maintenance parts are
approaching the end of service life.
Sets whether to light the «ATTENTION»
lamp when the supplies or maintenance
parts are approaching the end of service
life.
Selects the information to be displayed on
the standby screen.
Adjusts the contrast of the display.
Value range: -10 to +10
Sets the buzzer volume when an error
occurs.
Print Completion Buzzer Volume
Sets the buzzer volume when the printing
has completed.
Sets the volume of the AirPrint buzzer.
To Next Page
Loading...
