Printronix LP654C - Page 125

- 126 -
Item
Factory
default
settings
Description
Card Hold Buzzer Volume
Low
Sets the buzzer volume when the IC card is
held.
Displayed when access control is enabled.
Time Setup
Date Format
yyyy/mm/dd
Sets the date in the format of yyyy/mm/dd.
Time Zone
+9:00
Sets the GMT time zone.
Value range: -12:00 to +13:00 (in
increments of 15 minutes)
Daylight Saving
Off
Sets the daylight saving (daylight saving
time).
Setting method
Manual
Setup
Selects how to set the time.
SNTP Server(Primary)
(Blank)
Sets the SNTP server used to set the
current date and time. Up to 64 characters
can be used.
Displayed when [Auto Setup] is selected as
the setting method.
SNTP Server(Secondary)
(Blank)
Time Setting
2001/01/01
00:00:00
The time is set at factory delivery. Change
the date and time if necessary.
Displayed when [Manual Setup] is selected
as the setting method.
Power Setup
Auto Power Off
Auto Config
Sets the operation of Auto Power Off.
Auto Config: Auto Power Off does not work
for network (wired/wireless) connection.
Enable: Auto Power Off works regardless of
the connection method.
Disable: Auto Power Off does not work.
Tray Setup
Unit of Measurement
millimeter
Sets the unit of measurement for the custom
size (mm/inch).
Default Paper Size
A4
Sets the default paper size of a custom size.
Others Setup
Paper Feed
Roller
Counter
Clear
MP Tray Clear
Execute
Clears the counter after the paper feed roller
of the MP tray is replaced.
Tray1 Clear
Execute
Clears the counter after the paper feed roller
Tray 1 is replaced.
Tray2 Clear
Execute
Clears the counter after the paper feed roller
Tray 2 is replaced.
Tray3 Clear
Execute
Clears the counter after the paper feed roller
Tray 3 is replaced.
Tray4 Clear
Execute
Clears the counter after the paper feed roller
Tray 4 is replaced.
Flash
Memory
Setup
Initialize
Execute
Initializes the flash memory.
Format Partition
PCL
Formats the specified partition of a flash
memory.
Job Log
Setup
Save Job Log
Disable
Sets whether to save a log of print data.
Clear Job Log
Execute
Clears the log of saved print data.
Displayed when [Save Job Log] is enabled.
Security
Setup
Access Control
Disable
Sets whether to enable access control.
User Counter Report
Execute
Prints a user counter report. Displayed
when access control is set to [Enable] and
[Save Job Log] is enabled.
Language
Setup
Select Language
English
Selects the display language of the display.