ProntoNet
What’s New
27
Version
4.5.0
Date 30/06/2006
N
Alarm notification via e-mail
The alarms dialog permits the user to program several e-mail addresses. These
addresses will receive an e-mail with the alarm information.
N
Remote control changes – ProntoNet will send status information
automatically
Another TCP port (50035) must be enabled. ProntoNet will send status information
automatically when any of its status parameters change.
N
IP communications in line 2
There are two different operation modes when NET=IP: SIMPLE and DOUBLE mode. In
SIMPLE mode, the unit will work as usual, that means, It cannot establish two
independent communications via IP. In DOUBLE mode, the unit can establish two
independent communications via IP.
In DOUBLE mode via IP, the following restrictions will be applied:
1.- Encoder 1 and Encoder 2 can only be set in MONO.
2.- Encoder 2 (assigned to line 2) can only be set in G722.
N
Scheduler
With the Scheduler, the user can program automatic calls and their duration. In addition,
calls recurrence can be also defined.
N
Locking the keypad
In previous versions, they keypad could only be locked by pressing a key combination.
Now, the user will be able to lock the keypad with a password.
N
DTMF decoder
It is possible to program a GPO to be enabled when a DTMF is detected in either
Decoder. The decoder number and the DTMF which will enable the GPO must be defined
by the user.
To Next Page
Loading...
