Prodys ProntoNet - Page 169

ProntoNet
What’s New
54
Version 3.2.0
Date 22/12/2004
C
WARNING! THIS VERSION OR LATER, THE APTX MODES ARE NOT COMPATIBLE
WITH OLDER VERSIONS OF PRONTONETS
It has been detected that ProntoNet with older version is not compatible with Aptx codecs
of other manufacturers. All aptX modes has been modified to solve this problem.
N
Alarms Monitoring from the web browser.
For more information see appendix “About 3.2.0 version” at the end of this document.
N
Alarms SNMP traps available.
For more information see appendix “About 3.2.0 version” at the end of this document.
N
New GPIO functionalities: it is possible assign special functions to the GPIO inputs and
outputs.
For more information see appendix “About 3.2.0 version” at the end of this document.
Version 3.1.2
Date 03/12/2004
N New User’s Manual version (3.1.2)
N Aptx ENH available.
N PCM 24 bits available.
N AES/EBU transparent mode.
N
STREAMING ADVANCED OPTIONS:
Streaming has been improved allowing the setting of advanced configuration parameter to
specify the maximum delay in the line (in ms) according to the user. Range: 0 ms – 500
ms.
N Ancillary data Decoder configuration in SYS option.
Version 3.0.3
Date 1/10/2004
N New Version of the User’s Manual
N
The backup facility is enabled. This mode allows to use the ISDN like backup line in the
case the unit works in IP or X21 mode and the communication were lost in one of both
lines.
N
Improvement of delays in the IP streaming. In low delay audio modes the delay is
around 10 ms.
N
Automatic redial. From the web page it is possible to configure the number of redials. It
works also if the unit was connected and it is rebooted.
N Activate-Deactivate the fan from the menu.
N Ancillary Data. The following improvements have been introduced: