ProntoNet
What’s New
55
Decoder ancillary data configuration is possible. RS232 and GPIO are configured
separately, that is, it is possible to enable the ancillary data reception through RS232
or GPIO port.
The display shows information about selected speed in each RS232 port.
If the Encoder works in automatic mode, it is possible to select if the unit will send
ancillary data in case that they were received from the other side.
N
Advanced configuration menu. It is possible to configure the Time To Live (TTL)
parameter on multicast connections. This menu will be completed in future versions.
C The starting time of the unit is shorter.
F The 2.0.7 version lost the line 2 configuration when the unit was rebooted.
F There were audio drops in IP at AAC LC 64 Kbps.
F The GPIO information was shown wrong on the display.
Version
2.0.7
Date 16/07/2004
N First Version released.
To Next Page
Loading...
