Prontonet User’s Manual v410 46
LINE1 LOCAL NUMBER
-
LINE1 CNUM MODE
{ON}OFF
LINE1 SPID NUMBER
-
LINE1 CNUMS
{N1}N2 N3
LINE1 CALLING NUM1
-
calls made from these CNUM numbers. It is possible to program each line
separately.
SPID
: When you are using NAT1 or DMS100 you must enter the correct Service
Profile ID (SPID) numbers for the ISDN BRI circuit.
Automatic or manual response
: When automatic response is selected, the
unit will connect automatically to an incoming call, always doing so when there is
no restriction imposed by the local number or other such call filters. In manual
mode, the incoming calls are indicated on-screen and the user simply presses the
corresponding CALL key to go ahead and connect that line.
The ISDN parameter configuration screens are as follows:
LNUM:
CNUM
SPID:
O
O
To Next Page
Loading...
