PROEMION CANlink wireless 3002 - Page 103

Device Manual CANlink wireless
Operation
PROEMION GmbH | Phone: +49 661 9490-600 | Fax: +49 661 9490-666 | info@proemion.com | proemion.com | Version 1.0 98
© 2016RM MICHAELIDES● VX.X ● Device Manual CANlink 5000 series © 2016RM MICHAELIDES● VX.X ● Device Manual CANlink 5000 series © 2016 PROEMION GMBH > 1.0 EN > Device Manual CANlink wireless 3000 series
Parameter Description
P
ASSWORD
Input field for the password.
(not visible when PEAP is selected under authentication type.)
SHOW PASSWORD
Enabled: password is shown.
Disabled: placeholders (*) are shown for the password.
WLAN settings field
In the AUTOMATIC WLAN CONNECTION field, define the parameters for the CAN-CAN-WLAN
Bridge.
Parameter Description
ENABLE
Enable/disable automatic WLAN connection.
R
EMOTE ADDRESS
Input field for the IP address or URL of the slave to be connected.
REMOTE PORT
Input field for the port number of the slave to be connected.
R
EMOTE PROTOCOL
Selection for the transmission protocol:
TCP
UDP
Automatic WLAN connection field
In the IP SETTINGS field, define the parameters for a network.
Parameter Description
DHCP
MODE
C
LIENT
: Parameters are automatically assigned by a DHCP server in
the network. Fields not required are grayed out.
DISABLED: For assignment of a fixed IP configuration within a
network.
H
OST NAME
Input field for the device name in the WLAN network.
IP
ADDRESS
Input field for the IP address.
N
ETWORK MASK
Input field for the network mask.
GATEWAY ADDRESS
Input field for the gateway address.
PRIMARY DNS SERVER
Input field for the primary DNS server.
S
ECONDARY
DNS
SERVER
Input field for the secondary DNS server.
IP Settings field