Device Manual CANlink wireless
Operation
PROEMION GmbH | Phone: +49 661 9490-600 | Fax: +49 661 9490-666 | info@proemion.com | proemion.com | Version 1.0 99
© 2016RM MICHAELIDES● VX.X ● Device Manual CANlink 5000 series © 2016RM MICHAELIDES● VX.X ● Device Manual CANlink 5000 series © 2016 PROEMION GMBH > 1.0 EN > Device Manual CANlink wireless 3000 series
In the SOCKET SERVER field, define the parameters for the network connections to be received.
Parameter Description
ENABLE
E
NABLE/DISABLE SOCKET SERVER. If this function is enabled, a
socket connection can be established to this CANlink wireless on
the specified port using the TCP or UDP protocol.
PORT NUMBER
Input field for the port number.
PROTOCOL
Selection for the transmission protocol:
TCP
UDP
Socket server field
In the CURRENT CONNECTION INFORMATION field, enable/disable the SCAN CURRENT
CONNECTION INFORMATION DURING STARTUP
function. If this feature is activated, the current
SSID, BSSID, RSSI (Received Signal Strength Indicator), channel, IP address, network mask,
gateway address, primary and secondary DNS are requested while socket and Bluetooth SPP
connections are inactive. These parameter are stored in the CANopen object dictionary of the
device.
For futher information regarding the specific indexes and sub indexes, please refer to the
document "CANlink wireless series 3000 - CANopen Object Dictionary - EN.pdf"
To Next Page
Loading...
