6.6 Operating diagram
Access code
–
Access to the setting menu can be blocked with an access code
–
If the access code has been correctly selected for a setting menu, then all of the
other setting menus are also accessible
Fundamentally the continuous displays 1 - 3 and the calibration menu are freely
accessible. All of the other menus can be disabled by the access code in such a
way that the set values are displayed but cannot be changed. The default value
of the access code is "5000".
–
If no key is pressed within 60 seconds, the device will return to the continuous
display 1, the access code is re-enabled and access is restricted
Operating diagram/ Display Symbols
64
To Next Page
Loading...
