The following administration functions are available to manage the
commands (program lines):
1 - Reprogram program line (
‘New’
)
2 - Check program line (
‘Show’
)
3 - Change program line (
‘Change’
)
4 - Clear individual program line (
‘Clear’
)
(5 - Clear the entire program (
‘Clear all’
one level higher))
CAUTION!
The pump does not perform any plausibility check.
Please ensure before using that the timer actually
does what you expect of it. Please consider the
consequences for your system.
CAUTION!
A program set up in
‘Automatic’
-
‘on’
metering
mode will not function in
‘Automatic’
-
‘off’
metering mode and vice versa.
CAUTION!
If you wish to use automatic summer time adjust‐
ment (
‘Settings’
-
‘Time’
) avoid any triggering
events between 02:00 a.m. and 03:00 a.m.
Restriction with day numbers
If you wish to start an action on a certain day of
each month, note that the timer only permits days
01 - 28.
Using Config I/Os
If you wish to use Config I/Os as inputs or outputs,
you first need to configure them as a ‘Timer input’
or ‘Timer output’ under ‘Menu / Information
è
Settings
è
Config I/Os
è
...’.
11.3.2.1 Reprogramming program line (
‘new’
)
CAUTION!
If the
‘Timer state’
is set to
‘active’
, the pump can
neither be set nor programmed!
To do so, set the
‘Timer state’
under
‘Activation’
to
‘inactive’
.
11.3.2.1.1 Principle construction of a program line
In principle, an (imaginary) program line / instruction is set up as
follows:
Set up /
‘Menu’
80
To Next Page
Loading...
Need help?
General
