Proyecson PAA20+ - Page 31

Figure 7.2.5C
Output Message Terminator: This field lets you choose the message
terminator for output messages.
You can choose between:
• \r - “Return command”, 0x0D in hexadecimal.
• \n - “New line command”, 0x0A in hexadecimal.
• \r\n - “Enter command”, a return command followed by a new line
command.
The factory default message terminator is the “return” command. You may
see the selection tab options in Figure 7.2.5D.
INSTALLATION MANUAL: PAA20+ V 2.0 (10/2021) 31