Proyecson PAA20+ - Page 37

Figure 7.2.6G
The “Default” selection fills in the “Input n” fields to the factory default
messages.
Input Message Terminator:
As in the Output page, this field let you choose the message terminator for
Input messages.
You can choose between:
• \r - “Return command”, 0x0D in hexadecimal.
• \n - “New line command”, 0x0A in hexadecimal.
• \r\n - “Enter command”, a return command followed by a new line
command.
The factory default message terminator is the “return” command.
Actual firmware version limits the message length to thirty-four (34)
characters in the “Input codes” fields.
INSTALLATION MANUAL: PAA20+ V 2.0 (10/2021) 37