107
(QCT) #configure
(QCT) (Config)#lldp timers interval 60 hold 5 reinit 3
2. Enable port 0/3 to transmit and receive LLDP PDUs.
(QCT) (Config)#interface 0/3
(QCT) (Interface 0/3)#lldp transmit (QCT) (Interface 0/3)#lldp receive
3. Enable port 0/3 to transmit management address information in the LLDP PDUs and to send topology
change notifications if a device is added or removed from the port.
(QCT) (Interface 0/3)#lldp transmit-mgmt
(QCT) (Interface 0/3)#lldp notification
4. Specify the TLV information to be included in the LLDP PDUs transmitted from port 0/3.
(QCT) (Interface 0/3)#lldp transmit-tlv sys-name sys-desc sys-cap port-desc
5. Set the port description to be transmitted in LLDP PDUs.
(QCT) (Interface 0/3)#description “Test Lab Port”
6. Exit to Privileged EXEC mode.
(QCT) (Interface 0/3)# <CTRL + Z>
7. View global LLDP settings on the switch.
(QCT) #show lldp
LLDP Global Configuration
Transmit Interval..................... 60 seconds
Transmit Hold Multiplier.............. 5
Reinit Delay.......................... 3 seconds
Notification Interval................. 5 seconds
8. View summary information about the LLDP configuration on port 0/3.
(QCT) #show lldp interface 0/3
LLDP Interface Configuration
Interface Link Transmit Receive Notify TLVs Mgmt
--------- ------ -------- -------- -------- ------- ----
0/3 Down Enabled Enabled Enabled 0,1,2,3 Y
TLV Codes: 0- Port Description, 1- System Name
2- System Description, 3- System Capabilities
4- Organization Specific
9. View detailed information about the LLDP configuration on port 0/3.
To Next Page
Loading...