203
(R9) (Config-router)#network 172.18.1.24 mask 255.255.255.252
(R9) (Config-router)#network 172.17.1.4 mask 255.255.255.252
(R9) (Config-router)#network 172.17.1.8 mask 255.255.255.252
(R9) (Config-router)#network 172.17.1.12 mask 255.255.255.252
(R9) (Config-router)#network 172.19.1.28 mask 255.255.255.252
(R9) (Config-router)#network 172.19.1.32 mask 255.255.255.252
22. Configure the loopback addresses of routers in AS 65001.
(R9) (Config-router)#network 192.168.0.1 mask 255.255.255.255
(R9) (Config-router)#network 192.168.0.2 mask 255.255.255.255
(R9) (Config-router)#network 192.168.0.9 mask 255.255.255.255
(R9) (Config-router)#network 192.168.0.11 mask 255.255.255.255
(R9) (Config-router)#neighbor 192.168.0.11 remote-as 65001
(R9) (Config-router)#neighbor 192.168.0.11 description R7
(R9) (Config-router)#neighbor 192.168.0.11 next-hop-self
(R9) (Config-router)#neighbor 192.168.0.11 update-source loopback 0
(R9) (Config-router)#neighbor 192.168.0.1 remote-as 65001
(R9) (Config-router)#neighbor 192.168.0.1 description R1
(R9) (Config-router)#neighbor 192.168.0.1 next-hop-self
(R9) (Config-router)#neighbor 192.168.0.1 update-source loopback 0
(R9) (Config-router)#neighbor 192.168.0.2 remote-as 65001
(R9) (Config-router)#neighbor 192.168.0.2 description R2
(R9) (Config-router)#neighbor 192.168.0.2 next-hop-self
(R9) (Config-router)#neighbor 192.168.0.2 update-source loopback 0
(R9) (Config-router)#neighbor 172.19.1.29 remote-as 65049
(R9) (Config-router)#neighbor 172.19.1.29 description R3
(R9) (Config-router)#exit
(R9) (Config)#exit
7.5.3.2. Configuring BGP on Router 3
To configure R3 as shown in Figure 32:
1. To make it easier to determine which device is being configured, set the name of router (R3) as the
system prompt.
(QCT) #configure
(QCT) (Config)#hostname R3
(R3) (Config)#
2. Enter Global Config mode and enable routing on the system.
To Next Page
Loading...