44
Quanta OS Startup -- Main Menu
1 - Start Quanta OS Application
2 - Display Utility Menu
Select (1, 2):
For information about the Boot menu, see “Utility Menu Functions”.
5. If you do not start the boot menu, the operational code continues to load.
After the switch boots successfully, the User login prompt appears and you can use the local terminal to
begin configuring the switch. However, before configuring the switch, make sure that the software version
installed on the switch is the latest version.
2.3.1. Utility Menu Functions
Note: Utility menu functions vary on different
platforms.
The
following example
might not represent the
options available on your platform.
You can perform many configuration tasks through the Utility menu, which can be invoked after the first part
of the POST is completed.
To display the Utility menu, boot the switch observe the output that prints to the screen. After various
system initialization information displays, the following message appears:
Select startup mode. If no selection is made within 3 seconds,
the Quanta OS Application will start automatically...
Quanta OS Startup -- Main Menu
1 - Start Quanta OS Application
2 - Display Utility Menu
Select (1, 2):
Press press 2 within three seconds to start the Utility menu. If you do not press 2, the system loads the
operational code.
After you press 2 the following information appears:
Quanta OS Startup -- Utility Menu
To Next Page
Loading...
Need help?
General