163
Management access will be blocked for the duration of the transfer
Are you sure you want to start? (y/n)
4. After you confirm the download information and the script successfully downloads, it is automatically
validated for correct syntax.
Are you sure you want to start? (y/n) y
Validating configuration script...
Configure
ip host labpc1 192.168.3.56 ip host labpc2 192.168.3.58 ip host labpc3 192.168.3.59
exit
Configuration script validated.
File transfer operation completed successfully.
5. Run the script to execute the commands.
(QCT) #script apply labhost.scr
Are you sure you want to apply the configuration script? (y/n)y configure
ip host labpc1 192.168.3.56
ip host labpc2 192.168.3.58 ip host labpc3 192.168.3.59
exit
Configuration script 'labhost.scr' applied.
6. Verify that the script was successfully
applied.
(QCT) #show hosts
.
.
.
Configured host name-to-address mapping:
Host Addresses
------------------------ ------------------------
labpc1 192.168.3.56
labpc2 192.168.3.58
labpc3 192.168.3.59
6.2. Enabling Automatic Image Installation and System Configuration
To Next Page
Loading...
Need help?
General