73
partner/long
0/3 actor/long 10G Full False
partner/long
0/6 actor/long 10G Full False
partner/long
0/7 actor/long 10G Full False
partner/long
4. (Optional) Enable LACP Fallback feature which enabled the switch keep one LACP member port link up even
if LACP port doesn’t receive the LACP message from the other side.
(QCT) #(if-port-channel ch1)#lacp fallback
5. (Optional) Verify LACP Fallback feature of Port-channel 1.
(QCT) #show interface port-channel 1
Port Channel ID................................ 1
Channel Name................................... ch1
Link State..................................... Down
Admin Mode..................................... Enabled
Link Trap Mode................................. Disabled
STP Mode....................................... Enabled
Type........................................... Dynamic
Port-channel Min-links......................... 1
Load Balance Option............................ 3
(Src/Dest MAC, VLAN, EType, incoming port)
LACP Fallback Mode............................. Enabled
LACP Fallback Timeout.......................... 5
LACP Min. Links................................ 1
Mbr Device/ Port Port Fallback
Ports Timeout Speed Active
------ ------------- --------- ------- ---------
0/1 actor/long 10G Full False None
partner/long
0/2 actor/long 10G Full False None
3.4.2. Configuring Static Port-channels
The commands in this example show how to configure a static Port-channel on a switch. The Port-channel
number is 3 (ch3), and the member ports are 10, 11, 14, and 17. To configure the switch:
To Next Page
Loading...
Need help?
General