170
Protocol....................................... nfs
Switch-chip-register........................... TRUE
(QCT) (Config)#
(QCT) #write core test
The configured protocol nfs test PASS (QCT) #
6.3.2. Using TFTP or FTP to Download a Core Dump
Use the following commands to download a core dump file via TFTP. To use FTP, substitute
ftp
for
tftp
in the
commands.
(QCT) #config
(QCT) (Config)#exception protocol tftp
(QCT) (Config)#exception dump tftp-server 192.168.1.2
(QCT) (Config)#show exception
Coredump file name............................. core
Coredump filename uses hostname................ FALSE
Coredump filename uses time-stamp.............. TRUE
TFTP server IP................................. 192.168.1.2
File path...................................... ./.
Protocol....................................... tftp Switch-chip-
register........................... FALSE
(QCT) (Config)#
(QCT) #write core test
The configured protocol tftp test PASS (QCT) #
6.4. Setting the System Time
The switch uses the system clock to provide time stamps on log messages.
Additionally,
some show commands
include the time in the
command
output. For
example,
the show users
login-history
command includes
a
Login Time field. The system clock provides the information for the Login Time field.
You can configure the system time
manually,
or you can
configure
the switch to obtain the time by using a
Simple Network Time Protocol (SNTP) server. A network SNTP server can provide more accurate switch
clock time synchronization than manually-configured time.
Note: The manually-configured local clock settings are not retained across a system reset if the
platform does not include a Real Time Clock (RTC).
The SNTP client on the switch can request the time from an SNTP server on the network (unicast).
To Next Page
Loading...
Need help?
General