Quanta Cloud Technology QuantaMesh QNOS5 User Manual

34
 Proprietary BGP MIB support for reporting status variables and internal counters.
 Additional route map support:
o Match as-path
o Set as-path
o Set local-preference
o Set metric
 Supports for inbound and outbound neighbor-specific route maps.
 Handles the BGP RTO full condition.
 Supports for the show ip bgp command.
 Supports for the show ip bgp traffic command.
 Supports for the bgp always-compare-med command.
 Supports for the maximum number of BGP neighbors: 128.
 A prefix list is supported to filter the output of the show ip bgp command.
 Configurable maximum length of a received AS_PATH.
 Show command to list the routes accepted from a specific neighbor.
 Show command to list the routes rejected from a specific neighbor.
 Supports for BGP communities.
 Supports for IPv6.
 IPv6 Transport and Prefix list
Supports for BGP peer templates to simplify neighbor configuration.
1.5.4. VLAN Routing
QNOS software supports VLAN routing. You can also configure the software to allow traffic on a VLAN to be
treated as if the VLAN were a router port.
1.5.5. IP Configuration
The switch IP configuration settings to allow you to configure network information for VLAN routing
interfaces such as IP address and subnet mask, MTU size, and ICMP redirects. Global IP configuration
settings for the switch allow you to enable or disable the generation of several types of ICMP messages and
enable or disable the routing mode.
1.5.6. Address Resolution Protocol (ARP) Table Management

Quanta Cloud Technology QuantaMesh QNOS5 Specifications

General

Brand	Quanta Cloud Technology
Model	QuantaMesh QNOS5
Category	Network Router
Language	English